When installing a new stability room, freezer, or temperature-controlled enclosure, it’s easy to focus on the end goal: qualified, operational equipment ready for use. But successful installation depends on much more than delivery and assembly—it requires careful coordination, site readiness, and regulatory alignment from the very beginning.
At DH Lab, we specialise in supplying and installing Parameter Generation & Control equipment across the UK and Ireland, working closely with laboratories to ensure installation is seamless, compliant, and fit for purpose. Here’s what you need to consider before installation begins.
- Physical Space and Access Planning
Start by confirming that your site can physically accommodate your chosen chamber—not just in its final location, but also during delivery. We’ve seen too many cases where walk-in chambers can’t pass through doorways or corridors, leading to costly delays.
DH Lab conducts pre-installation site surveys to ensure your space is suitable and that installation will proceed smoothly. This includes checking ceiling heights, floor loads, door access, and ventilation.
- Power, Water, and Drainage
Most controlled environments require specific utility connections. Stability chambers, for example, may require:
- Single or three-phase power with specific voltage
- Water supply (often purified or deionised)
- Drainage points for condensate or humidity control
- Adequate ventilation or chilled water for compressors
Our team works with your facilities engineers to identify requirements in advance, ensuring services are in place and correctly specified before installation begins.
- Temperature and Humidity Stability
The environment surrounding your chamber can impact performance. A unit placed in a hot, poorly ventilated room may struggle to maintain internal conditions. Likewise, proximity to exterior walls can cause seasonal variability.
We advise on room placement and HVAC requirements to ensure stable, validated performance from day one. Our recommendations are based on years of experience and insight into how chambers perform in real-world conditions—not just the manufacturer’s spec sheet.
- Compliance, Validation, and Documentation
Whether your chamber is used for GMP stability studies or general storage, regulatory compliance matters. Installation is not complete until IQ (Installation Qualification), OQ (Operational Qualification), and, where needed, PQ (Performance Qualification) have been documented and approved.
DH Lab provides full validation support—including calibrated sensors, mapping services, and documentation tailored to your regulatory needs. We’ll even liaise with your QA and validation teams to ensure protocols match your internal standards.
- Ongoing Support After Installation
Your chamber’s lifecycle doesn’t end with installation. Ongoing support—from regular maintenance and requalification to emergency repairs and software upgrades—is essential for keeping your equipment compliant and dependable.
We remain your long-term partner, offering service plans, spare parts, upgrades, and training so your team can operate your equipment with confidence.
Final Thoughts
Installing a new stability chamber or cold storage room is a complex process—but it doesn’t need to be stressful. With DH Lab, you gain a partner that understands not only the technical requirements but also the regulatory, logistical, and operational factors that drive a successful installation.
Planning a new chamber? Contact us for expert guidance